Comments on: Bus Pirate V3 Enclosure – Alpha http://blog.synthetos.com/buss-pirate-v3-enclosure-alpha/ Complex Ideas... Sat, 06 Mar 2010 08:54:18 +0000 http://wordpress.org/?v=2.9.2 hourly 1 By: Bus Pirate feature requests? « Dangerous Prototypes http://blog.synthetos.com/buss-pirate-v3-enclosure-alpha/comment-page-1/#comment-25 Bus Pirate feature requests? « Dangerous Prototypes Wed, 30 Dec 2009 10:03:05 +0000 http://blog.synthetos.com/?p=147#comment-25 [...] of the fantastic laser etched case by Ril3y. All [...] [...] of the fantastic laser etched case by Ril3y. All [...]

]]> By: Laser etched Bus Pirate case « Dangerous Prototypes http://blog.synthetos.com/buss-pirate-v3-enclosure-alpha/comment-page-1/#comment-11 Laser etched Bus Pirate case « Dangerous Prototypes Tue, 24 Nov 2009 08:38:03 +0000 http://blog.synthetos.com/?p=147#comment-11 [...] made a fantastic laser etched Plexiglas case for his Bus Pirate v3 with a command cheat-sheet etched onto the bottom. There’s more [...] [...] made a fantastic laser etched Plexiglas case for his Bus Pirate v3 with a command cheat-sheet etched onto the bottom. There’s more [...]

]]> By: Ril3y http://blog.synthetos.com/buss-pirate-v3-enclosure-alpha/comment-page-1/#comment-10 Ril3y Thu, 19 Nov 2009 14:12:39 +0000 http://blog.synthetos.com/?p=147#comment-10 If you mean for the screw to sit flush into the bottom then.. Kinda. You have to think about the width of the plexiglass. This is 1/8 plexiglass. So you would need the screw to be able to thread into the 1/8 enough so it wont fall off. Even on fine threaded screws this might not be possible. However and alternative option would be to bring a "footprint" so that there are no holes in the bottom at all and it will be glued (see weldon ) onto the top 1/8 part. Weldon: http://www.delviesplastics.com/mm5/merchant.mvc?Screen=CTGY&Store_Code=DPI&Category_Code=Acrylic_Cement If you mean for the screw to sit flush into the bottom then.. Kinda. You have to think about the width of the plexiglass. This is 1/8 plexiglass. So you would need the screw to be able to thread into the 1/8 enough so it wont fall off. Even on fine threaded screws this might not be possible. However and alternative option would be to bring a “footprint” so that there are no holes in the bottom at all and it will be glued (see weldon ) onto the top 1/8 part.

Weldon: http://www.delviesplastics.com/mm5/merchant.mvc?Screen=CTGY&Store_Code=DPI&Category_Code=Acrylic_Cement

]]> By: obscurite http://blog.synthetos.com/buss-pirate-v3-enclosure-alpha/comment-page-1/#comment-9 obscurite Thu, 19 Nov 2009 14:02:12 +0000 http://blog.synthetos.com/?p=147#comment-9 Beautiful work as always. Would it be difficult to get the screws/posts to sit flush in the corners? Beautiful work as always. Would it be difficult to get the screws/posts to sit flush in the corners?

]]>